Subscribe to Our Youtube Channel
Related Manuals for JDS Uniphase T-BERD
Summary of Contents for JDS Uniphase T-BERD
- Page 1 T-BERD ⁄ MTS 5800 Handheld Network Test Family Ethernet, Fibre Channel, IP, and TCP/UDP Testing Manual...
- Page 3 T-BERD ⁄ MTS 5800 Handheld Network Test Family Ethernet, Fibre Channel, IP, and TCP/UDP Testing Manual Network and Service Enablement One Milestone Center Court Germantown, Maryland 20876-7100 USA Toll Free 1-855-ASK-JDSU • Tel +1-301-353-1560 • Fax +1-240-404-1996 www.jdsu.com...
- Page 4 Notice rate at the time of printing. However, information is subject to change without notice, and JDS Uniphase reserves the right to provide an addendum to this manual with information not available at the time that this manual was created.
- Page 5 equipment and batteries purchased from JDSU after 2005-08-13 can be returned for disposal at the end of its useful life. JDSU will ensure that all waste equipment and batteries returned are reused, recycled, or disposed of in an environmentally friendly manner, and in compliance with all applicable national and international waste legislation.
- Page 6 Ethernet, IP, and TCP/UDP Testing Manual...
- Page 7 Contents About this Manual Purpose and scope ......... . xvi Assumptions .
- Page 8 Contents Chapter 4 Ethernet and IP Testing About Ethernet and IP testing........22 Features and capabilities.
- Page 9 Contents Specifying traffic load settings....... . 58 Transmitting a constant load......58 Transmitting a bursty load.
- Page 10 Contents Things to consider ........103 About the One Way Delay test option and accessory kit .
- Page 11 Contents Viewing results for a specific stream..... . . 138 Viewing cumulative link results ......138 Viewing TCP Host results .
- Page 12 Contents Terminate mode........168 Loop back mode .
- Page 13 Contents Configuring layer 1 tests........197 BER testing layer 1 .
- Page 14 Contents Test selection ..........241 Running Enhanced RFC 2544 and FC tests .
- Page 15 Contents L-OAM Error History results ....... . 311 L3 Link Stats results ........312 L3 Link Counts results.
- Page 16 Contents Appendix A GPS Option for Timing Verification and Analysis GPS and Precision Timing ........338 Use of GPS Hardware in Testing.
- Page 17 About this Manual This prefix explains how to use this manual. Topics discussed include the following: – “Purpose and scope” on page xvi – “Assumptions” on page xvi – “Terminology” on page xvi – “Ethernet, IP, and TCP/UDP Testing Manual” on page xvii –...
- Page 18 Terminology The T-BERD 5800 is branded as the MTS-5800 in Europe, and it is inter- changeably referred to as the T-BERD 5800, MTS 5800, MTS-5800, MTS5800 and Media Test Set 5800 throughout supporting documentation.
- Page 19 – The Getting Started Manual provides basic instructions for setting up the T-BERD ⁄ MTS 5800, instrument specifications, and contact information for JDSU’s Technical Assistance Center (TAC). – Help. The topics addressed in the testing manuals are also available on the T-BERD ⁄...
- Page 20 About this Manual Safety and compliance information Symbol conventions Table 3 This symbol represents a general hazard. This symbol represents hazardous voltages. This symbol represents a risk of explosion. This symbol represents a Note indicating related information or tip. This symbol, located on the equipment, battery, or its pack- aging indicates that the equipment or battery must not be disposed of in a land-fill site or as municipal waste, and should be disposed of according to your national regula-...
Need help?
Do you have a question about the T-BERD and is the answer not in the manual?
Questions and answers