Connections On The Battery Charger Front; View Of The Battery Charger From Behind; Varta Element Backup Install Battery Charger - Varta element backup 6 Operating Manual

13.10.5

Connections on the battery charger front

No.
1
2
3
4
5
6
•
Press into the side notches of the battery charger with a screwdriver.
Aid: Slotted screwdriver.
•
Pull the battery charger approximately half-way out of the shaft.
•
Unplug the cables on the back.
•
Remove the battery charger from the shaft with
13.10.6

View of the battery charger from behind

13.10.7

VARTA element backup Install battery charger

To reinstall the battery converter, carry out the work steps in reverse order. The battery charger locks into
the end position. It is not necessary to use a screwdriver.
Note: Pay attention to the assignment of the battery cables.
Figure 14: Battery charger 1 – back
1 Cable of converter with inscription and 1 x colour:
96
Designation
Directions and warnings
Battery current 1
Do NOT use - battery current 2
Communication 3 (Comm 3) RJ45 socket
Communication 2 (Comm 2) RJ11 socket - NOT used
Communication 1 (Comm 1) Warning and Fault
both hands
.
violet