Replacement Power Operation Varta Element Backup; Replacement Power Box (Optional) - Varta element backup 6 Operating Manual

4

Replacement power operation VARTA element backup

Functional fault of the energy store.
Danger to life due to failure of medical equipment.
Contact with electrical voltage.
Danger to life due to electric shock.
Functional fault of the energy store.
Danger of material damage.
In the event of a power failure, the VARTA element backup automatically switches to the replacement power
mode. Thus, it is possible to continue to operate selected consumers.
•
The replacement power function of the VARTA element backup is not an uninterrupted power supply
(UPS) or safety power supply.
Note: A requirement for the replacement power mode is that the energy store is not empty.
The maximum available power is dependent on the number of battery modules installed and their charging
status. You will find the technical data in chapter 3.8 "Technical parameters of VARTA element backup",
beginning on page 20.
4.1

Replacement power box (Optional)

The replacement power box is intended for connecting consumers to the
replacement power network.
The following components are installed in the replacement power box:
•
F2 (safeguard consumer on the replacement power network),
•
Q2 (residual current device type B for consumers on the
replacement power network).
Note: If the replacement power box is not used, the corresponding
protection elements must be set up in the customer distribution (see
chapter 43: "Connection plans of the VARTA element backup", beginning on
page 43).
Installation of the replacement power box
•
Open the replacement power box.
•
Fasten the replacement power box to a flat and stable wall with screws.
•
Bore the necessary cable ducts.
•
Introduce the lines.
•
Clip the lines onto the labelled terminals.
•
Close the box.
22
DANGER
Do not connect any medical equipment to the energy store.
DANGER
Label the distributors for the replacement power.
Separate the replacement power circuit from the store.
Attention
Do not connect any information and communication equipment to the energy
store
Do not connect any cooling equipment to the energy store.