Fibre-Optic Port (Optional) - Bartec POLARIS PROFESSIONAL B7-72V1 Series User Manual

POLARIS PROFESSIONAL
POLARIS Panel PC Professional 15" up to 24"
5.7.4

Fibre-optic port (optional)

- for Zone 2 / 22
For the fibre-optic transmission a fibre-optic converter is used inside the POLARIS and it
converts the Ethernet/IP to fibre-optic signals (Ethernet/IP Ex e connection is not required).
For transmission a converter of the same type is needed for the non-hazardous area. This
is included in the scope of supply.
Technical Data
Connection of the POLARIS
External fibre-optic converter
Power supply
Data rate
Permissible ambient temperatures
Storage/transport
Operation
Multi-mode
Converter
Range
Fibre type
Min. transmitting power
Min. sensitivity
Wave length
Plug connector
Single-mode
Converter
Range
Fibre type
Min. transmitting power
Min. sensitivity
Wave length
Plug connector
The POLARIS fibre-optic connection must be observed when installing.
DANGER
There is a risk of fatal injury in an explosive atmosphere!
Protect the ST sockets from impact effects.

Make sure the plug on the fibre-optic cable is connected or closed before you put

the POLARIS into operation.
The fibre optic cable must laid with protection. (e.g. robust cabling, protective

tubes or cable channel)
Technical data subject to change without notice.
08/2019
ST connector
Connection of the ST connector/RJ 45
plug
external power pack
100 MBit/s
-20 °C bis +80 °C
0 °C bis +55 °C
MS400161
up to 2 km
62.5/125 µm or 50/125 µm
19 dBm
31 dBm
1310 m
ST
MS400163
up to 15 km
9/125 µm
15 dBm
31 dBm
1310 m
ST
Installation