Table of Contents
Advertisement
Basic
Safety Instructions
1.6.3
Inspection
1.6.4
Repairs
1.6.5
Commissioning
1.7
Ex Protection Type, Certification and Standards
1.8
Warranty
4/66
POLARIS PROFESSIONAL
POLARIS Panel PC Professional 15" up to 24"
Under EN 60079-17, EN 60079-19, IEC 60079-17 and IEC 60079-19, the owner/ managing
operator of electrical installations in hazardous areas is obliged to have these installations
checked by a qualified electrician to ensure that they are in a proper condition.
Repairs on explosion-protected operating equipment may be done only by authorised
persons working in accordance with the latest developments in technology and using
original spare parts. The applicable regulations must be observed.
Before commissioning, check that all components and documents are there.
Markings specifying Ex protection and certification are put on the device. For Ex protection
markings, see Chapter 3 "Technical Data".
The POLARIS PROFESSIONAL Panel PCs conform to Directive 94/9/EC for devices and
protective systems for use to their intended purpose in potentially explosive areas (ATEX
Directive). For the standards conformed to, see Chapter 3 "Technical Data".
WARNING
It is not permissible to make any modifications or implement any conversions
unless the manufacturer gives his approval in writing.
If components other than those specified are used, protection against explosion can no
longer be assured. It cannot be guaranteed that parts procured from other suppliers
have been designed and produced in conformance to safety requirements and with the
necessary stress tolerance.
Contact the manufacturer to obtain approval before making any modifications or
conversions. Use only original spare parts and original expendable parts.
The manufacturer grants a complete guarantee only and exclusively for the spare parts
ordered from him, the manufacturer.
- for Zone 2 / 22
Technical data subject to change without notice..
08/2019
Advertisement
Table of Contents
