Table of Contents
Advertisement
POLARIS PROFESSIONAL
POLARIS Panel PC Professional 15" up to 24"
5.2.2
Installation as a System Solution in the Stainless Steel Enclosure
Technical data subject to change without notice.
08/2019
- for Zone 2 / 22
Work steps
(1)
Insert the POLARIS into the cut-out in the enclosure.
(2)
From the back, place the reinforcement frame over the POLARIS.
(3)
Using the M4x12 (2) screws to fasten the mounting clamps (1) to the rear side of
the POLARIS and tighten to 1.37 Nm.
(4)
Tighten the terminal screw (3) on the reinforcement frame in the order
to a torque of 1.02 Nm.
Always tighten the mounting clamps crosswise.
The POLARIS is available as a ready-made system solution in a stainless steel enclosure
e.g. the "Exclusive" stainless steel enclosure, for floor, wall or table mounting.
Selecting the location
CAUTION
Pay attention to wall and ground condition!
A sufficiently stable wall (e.g. concrete or limestone) or floor (e.g. concrete) must
be selected for securing the load-bearing system.
The structural stability of the wall or floor must be able to bear 4 times the weight
of the POLARIS as system solution.
The support arm system must be assembled using suitable mounting materials
(M12) (e.g. dowels or stud bolts).
Number of mounting clamps
POLARIS 15"/17.3"/19.1"
POLARIS 24"
Installation
to
12 pieces
14 pieces
25/66
Advertisement
Table of Contents
