Installation As A System Solution In The Stainless Steel Enclosure - Bartec POLARIS B7-72V1 Series User Manual

Commissioning
EN 24/65
POLARIS PROFESSIONAL- for Zone 2/22
POLARIS Panel PC Professional 10,4" / 12,1" / 12,1" W
Work steps
(1) Insert the POLARIS into the cut-out in the enclosure.
(2) From the back, place the reinforcement frame over the POLARIS.
(3) Using the M4x12 (2) screws to fasten the mounting clamps (1) to the rear side of the
POLARIS and tighten to 1.37 Nm.
(4) Tighten the clamping screw (3) of the mounting clamps (see illustration 7) to a torque
of 1.02 Nm.
Always tighten the mounting clamps crosswise.
6.2.2

Installation as a System Solution in the Stainless Steel Enclosure

The POLARIS is available as a ready-made system solution in a stainless steel enclosure
e.g. for floor, wall or table mounting.
Selecting the location
COUTION
Pay attention to wall and ground condition!
A sufficiently stable wall (e.g. concrete or limestone) or floor (e.g. concrete) must be
selected for securing the load-bearing system.
The structural stability of the wall or floor must be able to bear 4 times the weight of
the POLARIS as system solution.
The support arm system must be assembled using suitable mounting materials
(M12) (e.g. dowels or stud bolts).
For POLARIS built into the enclosure door:
The open door must be supported and secured during the installation and servicing
phase. Otherwise the wall thickness specified may lead to the door sagging slightly when
open.
Anzahl der Haltekrallen
POLARIS Professional
10,4" / 12,1"/12,1" W
6 pieces
Technical data subject to change.
09/2020