WAGO-I/O-SYSTEM 750
753-540 4DO 230 V AC
Pos : 61.10 /Serie 753 ( WAGO-I/O-SYST EM)/Monti eren/Bus kl emme 753 entfernen @ 20\mod_1412665995998_21.doc x @ 165319 @ 3 @ 1
5.2.2
Removing the I/O Module
Remove pluggable connector!
Before removing a 753 Series I/O Module from the node, you must first remove
the pluggable connector from the module (see section "Connector Removal")!
1.
Remove the I/O module from the node by pulling the release tab.
Figure 9: Removing the I/O Module (Example)
Electrical connections for data or power contacts are disconnected when removing
the I/O module.
Pos : 61.11 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.1.0
Mounting
29