Table of Contents
Advertisement
EXPRESS
OK
4. INDICATORS
4.1 Main display items
On activation of the panel, the display shows the following:
EXPRESS
At the end of the start-up sequence, the main menu is displayed, as described below;
This screen enables the display of active motors, voltage on input and
2 3 0 v 7 . 0 A t o t
P1 (1) P2 (1) P3 (0)
total absorption of the panel:
• 230 V = Power supply voltage reading.
• 7.0 Atot = Total current absorbed by the panel.
• P1 ( 0 ) = Motor 1 deactivated
• P2 ( 0 ) = Motor 2 deactivated
• P3 ( 0 ) = Motor 3 deactivated
If operating modes are used with analogue signals, the main screen
2 3 0 v 7 . 0 A t 1 . 0 b
P1 (1) P2 (1) P3 (0)
also displays the input signal expressed as a percentage, in metres or
bar.
By pressing OK the user can view the screen of each motor (P1, P2 and
2 3 0 v 0 . 0 A 1 . 0 @
MAN () AUT (*) P1
1
P3), where the following is displayed:
•230 V = Power supply voltage reading.
•0.0 A = Current absorbed by connected load.
•1.0 ( ) = Power factor of connected load.
•MAN (*) = Panel set to manual mode.
•AUT (*) = Panel set to automatic mode.
•MAN ( ) AUT ( ) = Panel on standby.
•P1 = Motor 1 deactivated.
•P1 = Motor 1 active.
Display of values and programming.
Red led: general alarm
SETUP (or multifunction) button
UP arrow button
DOWN arrow button
OK button
E L E N
j
MODEL
• P1 ( 1 ) = Motor 1 active.
• P2 ( 1 ) = Motor 2 active
• P3 ( 1 ) = Motor 3 active
4 5
Advertisement
Table of Contents
