6.3. Installation surface dimensions
When installing the robot controller by mounting in a rack, use the holes located at both
ends of the front panel to fix the robot controller to the rack. The side bracket [1] in Fig.
6.3 is an option.
6.4. Precautions for Rack Mounting
When mounting the robot controller TS3100 to the rack, please follow the precautions
below,
a) When installing the robot controller by mounting in a rack, use the holes located at
both ends of the front panel to fix the robot controller to the rack (Side brackets are
required.)
If the rack is completely airtight, open air release holes, ventilate
the air forcibly with a fan, or conduct indirect cooling to release
heat from the rack.
Otherwise, heat is confined inside the rack and the robot
controller, causing failure.
Fig. 6.3 Screw hole dimensions for securing controller
TRANSPORTATION AND INSTALLATION MANUAL
470
450
420
!
CAUTION
68