5.0
TD-107
Oil Content Monitor
Operation Manual
CONNECTIONS FOR FLUSH VALVE ACTUATOR
If your monitor is equipped with an optional Flush Valve Actuator, make the following
connections. See also, Appendix K: General Arrangement Drawings.
The actuator is manipulated by instrumentation and control logic supplied by the customer.
Three wires are used to control the position of the actuator.
Note that the actuator is motivated by 230VAC signals. Therefore, exercise
extreme caution when making these connections and performing tests as
contact with these wires can be lethal!
•
The white wire must be tied to one of the legs of the customer's supply.
APPENDIX I
52