Table of Contents
Advertisement
Q & A
How to indicate cutting angle, optical fiber's angle and
core/clad deviation.
HOW TO
·Refer to [Option menu].
Difference between estimated splice loss and
measured splice loss.
HOW TO
·The estimated splice loss is just a result from computation
so it has to be used for reference only.
SLEEVE HEATER
The sleeve heater does not give sufficient shrinkage.
HOW TO
·Increase the duration of heating time.
Refer to [Heat Menu] for more information.
The sleeve heater is overheated.
HOW TO
· Stop the operation of the heater by pressing
Turn off the power and contact UCLSWIFT Co., Ltd.
· When the sleeve is not separated from the heating plate,
use a cotton swab or a similar object to this to push or
remove the sleeve.
How to initialize the heating condition in the heat mode.
HOW TO
· Refer to [Heat Menu] for more information.
How to cancel the heating process.
HOW TO
· You cannot cancel the heating process by pressing
Press
one more time to cancel it
HEAT
.
HEAT
.
RESET
��
Advertisement
Table of Contents
