Table of Contents
Advertisement
Q & A
SPLICE
When an error message appears on the screen.
HOW TO
·Refer to the [Error message list] for detailed information.
Irregular or higher splice loss.
HOW TO
·Clean V-Groove, V-Block, reflector and object lens by referring
to [Maintenance of splice quality]. Replace electrode
by referring to [Electrode replacement]. Refer to the
"High estimated loss" from [Error message list].
· If optical fiber warps or is bent, place the optical fiber's bent
direction to face the bottom. Splice loss varies depending on
cutting angle, discharge condition and cleanliness level of
optical fiber. Splice loss is still high or irregular even after
implementin the above recovery measures, contact to UCLSWIFT.
Annual maintenance is required to keep splice quality.
Monitor is turned off suddenly.
HOW TO
·Press any key and check [Monitor Power Save].
The power of the splicer is turned off suddenly.
HOW TO
·Turn on the splicer again and check [Splicer Power Save].
Unable to change arc discharge amount and time.
HOW TO
·On SM, NZ, MM or AUTO mode, either discharge amount
or discharge time cannot be changed. Implement [discharge
amount calibration], and the discharge amount on these
modes is properly maintained. When used on another mode,
discharge amount and discharge time are automatically set to
prevent their alteration.
How to set pause.
HOW TO
·Refer to [Option Menu].
��
Advertisement
Table of Contents
