UCL SWIFT Swift K33A User Manual page 51

MENU
Clearance Upon final arrayal, it sets clearance of
cross section between both optical fibers.
Initial Discharge It sets initial discharge amount from
the beginning of discharge before optical
Amount
fiber's advance. If the value of initial
discharge amount is too low, the angle
of optical fiber's cross section is poor and
consequently, offset can be incurred on
the axis and if it is too high, optical fiber can
be burned too much or made round and
consequently, splice loss value can be big.
Initial Discharge It sets initial time from the beginning of
Time discharge before optical fiber's advance.
If [initial discharge time] is long, it means the
same that [initial discharge amount] gets big.
Overlap It sets duplication of optical fiber on optical
fiber's advance amount. If [initial discharge
amount] is weak or [initial discharge time]
is short, set the [overlap] somewhat small
and if discharge amount is strong and the
time is long, set it somewhat big.
Non Editable Editable
Non Editable Editable
Non Editable Editable
Non Editable Editable
��