UCL SWIFT Swift K33A User Manual page 30

OPERATION
Optical Fiber
� Choose the heater mode after the confirmation
of the length for the sleeve tube when placing a sleeve
tube on a heater.
� Place the spliced point in the middle of the sleeve
tube first. Then, checking out the heating part on the
heater an place the sleeve tube on right position.
sleeve tube properly. Especially,
SOC (Splice-On-Connector) should
be placed on the right side edge of
the heater in order to line up the
right end of the sleeve tube to the
Soc Connector
right side edge of the heater as
shown on the picture below (Right
Choosing improper mode picture). If SOC is placed in the
of the heater for a sleeve middle or on the left side, sleeve
tube may not shrink the tube of the SO does NOT shrink.
� After placing the optical fiber on the heater, press
to start the heater. (Operation time: about �� seconds).
� When the heater is complete, open the cover and remove the fiber
reinforced cooling Tray to go to the cooling sleeve.
button
��