Optical Fiber Is Thick; Optical Fiber Is Thin; Error On Cut Surface On Left, Right Or Both - UCL SWIFT Swift K33A User Manual

ERROR MESSAGE

Optical Fiber Is Thick

It is an error message generated when
optical fiber sealing part becomes
thicker than the standard after sealing.
HOW TO
· Reduce the overlap set value.
· Check whether discharge amount or
discharge time is set as too small
or too short respectively.

Optical Fiber Is Thin

It is an error message generated when
optical fiber sealing part becomes
thinner than the standard after sealing.
HOW TO
· Make adjustment to shorten the
pulling length of pulling splice.
· Check whether discharge amount or
discharge time is set as too big or too
long respectively.
Error on Cut Surface on Left,
Right or Both
It is an error message generated
when the cut surface of optical fiber is
poor quality.
HOW TO
· Check the state of optical fiber cutter.
· Cut the optical fiber yet again.
��