Table of Contents
Advertisement
Q & A
POWER
Unable to turn off the power by pressing
HOW TO
·Press the switch and hold it for about � second and
release the button when the monitor is turned off.
Unable to splice as number of times as the splicer normally
does with the battery that has been fully charged.
HOW TO
·If the power saving mode is not activated, the battery runs out
quickly. Please refer to [Setting Menu] for more information.
If the battery has not been used for a while, charge it again until
it is charged fully.
· Use a new battery if the current battery was used for a long
period of times and its suggested lifetime is passed. Since the
battery works based on chemical reactions, power generated
decreases at a low temperature and, in particular, it runs out
very quickly when the temperature is below zero.
Also, the battery runs out fast when it is used at a high
temperature because the power consumption increases.
If you cannot charge the battery fully, do as instructed below.
.
LED is not turned on while charging the battery.
HOW TO
·Disconnect the AC power cord from the charger and
connect the DC cord to the charging jack. Connect
the AC power cord in �� to �� seconds. The LED of the battery
is turned on red and charging begins
Remaining battery is not indicated.
HOW TO
·Charge the battery.
Remaining battery is not well displayed.
HOW TO
·Remaining battery display is for reference.
��
Advertisement
Table of Contents
