Table of Contents
Advertisement
FOR YOUR SAFETY
WARNING
!
Please, turn off the Swift K��A
and disconnect the AC power
cord from the AC adapter inlet
or the wall socket immediately
and contact UCLSWIFT Co., Ltd.
If any of following incidents
occurs while operating.
· Fumes, odor, noise or over-
heating.
· Liquid or foreign substances
fall into the device.
· The splicer is dropped or
damaged.
Use the supplied power cord with
the Swift K��A only. Using an
improper AC power cord may
cause fire, electric shock or
personal injury.
DO NOT touch the electrode
when the Swift K��A is on. The
high voltage and temperature
generated by electrode may
cause electric shock or burn.
Connect the supplied AC power
cord to the battery. Check to
ensure no dust or foreign sub-
stance on the AC plugs before
connecting it. Unsafe connection
may cause the fumes, fire or
damage to the Swift K��A and
result in serious personal
injury or death.
DO NOT touch the AC plugs,
AC power cable or the Swift K��A
with wet hands. It may cause an
electric shock.
Apply correct voltage. The
correct input AC power to the
adapter is AC ���-���V and
��-��Hz. Abnormally high AC
output voltage or irregular
frequencies are often genera-
ted by AC generator. Please
measure the AC output voltage
with a circuit tester. Sinceabnor-
mal high voltage and frequencies
may result in serious electric
shock, injury, death or damage
to the equipment, it is important
thatregularly check the generator
before use. DO NOT excessively
pull, amend, misuse or apply
heat to the AC power cable.
Using a damaged power cable
may result in fire or personal
injury. Connect �-core AC power-
cord. DO NOT use �-core, able
and plug.
DO NOT disassemble the AC
adapter, battery or the Swift K��A.
Anymodification may cause fire,
electric shock or personal injury.
When using the battery, follow
instructions below.
· Using battery other than in the
package or provided by UCL
SWIFTCo., Ltd may cause
fumes, damage to the device,
burn, serious injury or even
death.
· DO NOT throw the battery into
fire or an incinerator.
· DO NOT charge the battery
near a flame.
· DO NOT apply excessive shock
to the battery.
· If the battery isn't fully charged
or the green LED is not turned
on in about two hours, stop
charging immediately and
contact UCLSWIFT Co.,Ltd.
· DO NOT put anything on the
AC adapter while charging.
Use the supplied AC adapter
(F�-�) at all times. DO NOT use
other type of AC power cord and
the battery. Excessive electric
current may cause damage to
the machine and personal injury.
DO NOT run the Swift K��A near
flammable liquid or explosive
gas storage. The electric arc of
the Swift K��A may cause fire or
explosion.
DO NOT clean the Swift K��A
using compressed air or gas.
Please check the shoulder
�
Advertisement
Table of Contents
