Table of Contents
Advertisement
OPERATION
CLEAVING
THE FIBER
� Install the optical fiber on cutter as shown in the figure
below and check optical fiber's state and cutting length.
� When optical fiber is not properly installed, problems
may be incurred on cutting procedure.
� Pull down and press the cover to cleave the fiber.
Lift the cutting lever and take the optical fiber out.
� Remove the fiber fragments and dispose it in
a proper container.
Please read user manual of the cleaver for more
detailed information about the operation of the cleaver.
LOAD THE FIBER
TO SWIFT K��A
� Open the windshield cover and optical fiber.
� Put optical fiber between V-Groove and electrode.
Be careful not to make the tip of prepared optical fiber
bump against other objects.
� Fix the optical fiber with hands to prevent its move and
close the clamp with care.
� Install the optical fiber on the opposite side in the same way.
� Close the windbreak cover with care.
The better the optical fiber is installed at a proper location,
the shorter it takes for alignment.
��
Advertisement
Table of Contents
