Table of Contents
Advertisement
PRODUCT DESCRIPTION
SLEEVE HEATER
The sleeve heater is designed to strengthen the
fiber splice. To ensure maximum reinforcement
the following conditions must be met.
Heater
Cover-L
Heater
� After splicing the fiber splice must be visually perfect.
� The fiber and sleeve must be placed correctly in the
heater, failure to place the sleeve and fiber in the
correct position can result in incorrect heating and
possible damage to the splice joint.
� When splicing, the heater cover cannot be left open,
it must be in the fully closed position.
Heater
Cover-R
Window
Be careful not to wet the equipment. Maintain the unit
in a clean condition at all times because many of
splicing problems are caused by dust or moisture.
Keep and use the unit at room temperature as it could
be deformed by heat. Keep the equipment from being
shaken or physically impacted as it could be broken.
Never use organic solvent such as acetone except
alcohol to clean rubber part of the equipment.
Specification
No.
Subject
�
Applicable Cable
Diameter
�
Sleeve Length
�
Sleeving Time
�
Heat Temp. Range
Description
���μm, ���μm,
�.�~ �.�mm
��mm(standard)
��~�� sec
���°C ~ ��� °C
��
Advertisement
Table of Contents
