Potentiometer: Set; Rwg Electronic Position Transmitter - AUMA SAEx 07.2 Manual

Commissioning (optional equipment settings)
11.2.1.

Potentiometer: set

Information
11.3.

RWG electronic position transmitter

Technical data
Setting elements
78
SAEx 07.2 SAEx 16.2/SAREx 07.2
Figure 91: View on control unit
[1] Potentiometer
Due to the ratio of the reduction gearing, the complete resistance range/stroke is not
always covered. Therefore, external adjustment (setting potentiometer) must be
provided.
1. Move valve to end position CLOSED.
2. Turn potentiometer [1] clockwise to the stop.
End position CLOSED corresponds to 0 %
End position OPEN corresponds to 100 %
3. Turn potentiometer [1] slightly in opposite direction.
4. Perform fine-tuning of the zero point at external setting potentiometer (for remote
indication).
The RWG electronic position transmitter records the valve position. On the basis of
the actual position value measured by the potentiometer (travel sensor), it generates
a current signal between 0
Table 35: RWG 4020
Data
Output current I
a
1)
Power supply U
V
Max. current consumption
Max. load R
B
Impact of power supply
Load influence
Temperature impact
2)
Ambient temperature
Transmitter potentiometer
1) Power supply possible via: AC, AM actuator controls or external power supply
2) Depending on temperature range of the actuator: Refer to name plate
The RWG is housed in the actuator switch compartment. The switch compartment
must be opened to perform any settings. Refer to <Switch compartment: open>.
Setting is made via three potentiometers [1], [2] and [3].
SAREx 16.2 Control unit - electromechanical
ACExC 01.2 Intrusive Modbus RTU
20 mA or 4 20 mA.
3-wire and 4-wire systems
0 20 mA, 4 20 mA
24 V DC (18 32 V)
24 mA at 20 mA output current
600 Ω
0.1 %/V
0.1 %/(0 600 Ω)
< 0.3 ‰/K
60 °C to +80 °C
2-wire system
4 20 mA
14 V DC + (I x R ), max. 30 V
B
20 mA
(U 14 V)/20 mA
V
0.1 %/V
0.1 %/100 Ω
5 kΩ