Transport And Storage; Transport - AUMA SAEx 07.2 Manual

Transport and storage

4. Transport and storage
4.1.

Transport

Actuator
Weights
14
SAEx 07.2 SAEx 16.2/SAREx 07.2
For transport to place of installation, use sturdy packaging.
Suspended load!
Death or serious injury.
Do NOT stand below suspended load.
Attach ropes or hooks for the purpose of lifting by hoist only to housing and NOT
to handwheel.
Actuators mounted on valves: Attach ropes or hooks for the purpose of lifting
by hoist to valve and NOT to actuator.
Actuators mounted to gearboxes: Attach ropes or hooks for the purpose of lifting
by hoist only to the gearbox using eyebolts and NOT to the actuator.
Actuators mounted to controls: Attach ropes or hooks for the purpose of lifting
by hoist only to the actuator and NOT to the controls.
Respect total weight of combination (actuator, actuator controls, gearbox, valve)
Secure load against falling down, sliding or tilting.
Perform lift trial at low height to eliminate any potential danger e.g. by tilting.
Figure 10: Example: Lifting the actuator
Table 6:
Weight for ACExC 01.2 actuator controls
with electrical connection type:
AUMA Ex plug/socket connector with screw-type terminals (KT)
AUMA Ex plug/socket connector with screw-type terminals (KP)
AUMA Ex plug/socket connector with terminal blocks (KES), increased
safety Ex e
AUMA Ex plug/socket connector with terminal blocks (KES),
flameproof enclosure Ex d
1) Standard
SAREx 16.2 Control unit - electromechanical
ACExC 01.2 Intrusive Modbus RTU
Weight approx. [kg]
1)
14
12
14
16.5