Figure 17. Euro Connector Installed - ADTRAN Total Access 300 Series Installation And Maintenance Manual

6. Loosen each retaining screw and insert the wire into the appropriate slot (see Figure 14 on
7. Tighten the retaining screws.
8. Reinstall the Euro‐Connector in the Electronics Module.
Back of Electronics Module
9. Tie wrap and route these wires as shown above. This will prevent the connector from
10.Reinstall the rubber grommet when closing the Electronics Module.
6418771XGX-5B
page 27 and Table 6 on page 27).

Figure 17. Euro Connector Installed

coming loose when the Electronics Module is closed.
4
7 6 5 3 2 1
Euro-Connector
Tie Wrap wires as shown
Note: Even though there are brackets to
Rubber Grommet
Installation
position the Euro-Connector wires,
we recommend not using them. Use
of these brackets can "bind" the wires
when the Electronics Module is closed.
29