Figure 21. Wire Routing - ADTRAN Total Access 300 Series Installation And Maintenance Manual

Total Access 300 GigE SFU ONT with RF Overlay Installation and Maintenance Guide
6. Before closing the Electronics Module, route all wires as shown in Figure 21.
NOTE
When the wires are routed correctly, the Electronics Module will close and be
nearly flush with the housing. Some "slight spring" with the Electronics
Module is acceptable. However, it is critical that the fiber optic cable be free
from crimping or sharp bends.
7. While closing the Electronics Module, ensure that none of the wires are pinched.
8. Close the Electronics Module and secure by tightening the "Inner Security Screw" (see
34
Note: Do not tie wrap the
optical cable. Simply
route it as shown.
Figure 7 on page 19).

Figure 21. Wire Routing

Cover w/Lanyard
6418771XGX-5B