Installation; Shipping Contents; Required Tools - ADTRAN Total Access 300 Series Installation And Maintenance Manual

Installation

!
CAUTION
Electrostatic Discharge (ESD) can damage electronic components. When
handling modules, wear an antistatic discharge wrist strap to prevent
damage to electronic components. Place modules in antistatic packing
material when transporting or storing. When working on modules, always
place them on an approved antistatic mat that is electrically grounded.
After unpacking the ONT, inspect it for damage. Before planning the installation of the ONT,
the technician should do the following to verify component integrity.
1.Unpack both the ONT and power supply (packed separately) to ensure the units are visi‐
2. Examine the ONT enclosure, fiber management guide, associated terminals, weather
3. Examine the power supply to ensure that the UPS, battery and power cord are present
If damage has occurred, file a claim with the carrier then contact ADTRAN Customer Service.
Refer to "Appendix A, Warranty" for further information. If possible, keep the original
shipping container for returning the ONT for repair or for verification of shipping damage.

Shipping Contents

The contents include the following items:
• Total Access 361 or 362 Electronics Module
• Total Access GigE SFU ONT Job Aid (P/N 6418771XGX‐22)

Required Tools

Standard technician tools are used for a ONT installation (for example, drill, drill bits, side
cutters, screwdrivers, nut drivers, hex wrenches, wire strippers, etc.).
Specifically, the following tools are required for the installation of the ONT:
• Carpenter's level
• 3/32" screw driver
• 5/32" hex tamper‐proof bit
• 216‐Type can wrench
• Fiber splicing tools
6418771XGX-5B
bly intact and are not missing any components.
resistant grommets, fiber connector, telephone and Ethernet ports for usability.
and sound.
C A U T I O N C A U T I O N !
SUBJECT TO ELECTROSTATIC DAMAGE
OR DECREASE IN RELIABILITY.
HANDLING PRECAUTIONS REQUIRED.
Installation
15