Table of Contents
Advertisement
WIRING
The connectors are described in this section.
RJ-48C Connectors
Two RJ-48C connectors are located on the top end of the T1 ESF
CSU ACE. The NET connector connects the unit to the network.
The connector marked CPE connects the unit to the data terminal
equipment. These connectors have exactly the same pinouts.
See Table A-1 on page A-2 for the RJ-48 connector pin assignments.
EIA-232 Connector
The EIA-232 connector is used to connect the T1 ESF CSU ACE to a
proxy agent, T-Watch, an ASCII terminal, or a modem.
See Table A-2 on page A-2 for the connector pin assignments.
Connector Type = Female DB-25
61203025L1-1
T1 ESF CSU ACE User Manual
Chapter 2. Installation
2-3
Advertisement
Table of Contents
