Necessary Supplies - ADTRAN Total Access 300 Series Installation And Maintenance Manual

Total Access 300 GigE SFU ONT with RF Overlay Installation and Maintenance Guide
• RJ‐45/RJ‐11connector crimper
• RJ‐45 plugs: one for the 1187711G1 and two for the 1187712G1
• Two RJ‐11 plugs (when not using Two‐screw Terminal Bridges)
• A telephony/data communication test set
• PON power meter preferably with wave length filtering
• Fiberscope or videoscope
• Optical Time Domain Reflector meter calibrated for 1310 and 1490 nm output
• Composite fiber cable for non‐connectorized installation
• ONT mounting hardware
• Silicone sealant (and application material, i.e., cotton swabs)
• Bonding clamp for grounding and securing the composite cable on non‐connectorized
• 1 each, 60" Hi‐cap riser pipe (for composite cable installation)
• Tie wraps
• TexWipe
• TexWipe
Included with the SFU ONT packaging are 2 Two‐screw Terminal Bridges, fiber cable
management and strain relief, a fiber connector, and electronics/optics. For data and video
over IP, the connection to the SFU is through the RJ‐45 Ethernet connectors. For POTS, the
connection is made through 2 Two‐screw Terminal Bridges, or RJ‐11 connections.

Necessary Supplies

Make sure you have access to the following supplies:
• Appropriate surface anchors for mounting the ONT (each anchor rated to 15 lbs minimum)
• Assorted tie wraps for securing cabling and wiring
• SC/APC fiber connector (Green)
16
installations
TM
Alco pad for fiber cleaning
TM
cloth for fiber cleaning
6418771XGX-5B