Mounting The Enclosure; Figure 8. Enclosure Mounting Holes - ADTRAN Total Access 300 Series Installation And Maintenance Manual

Total Access 300 GigE SFU ONT with RF Overlay Installation and Maintenance Guide

Mounting the Enclosure

Use a maximum of a #10 screw to fit properly in the diameter of the mounting holes (see
Figure 8). Make sure to leave a minimum clearance of 2 inches from the hinges for opening the
door. Complete the following steps to mount the enclosure:
1.Using the enclosure as a template and a carpenter's level, mark the locations for the two
2. Pre‐drill the marked locations and install fasteners or anchors appropriate to the
3. Mount the ONT to the side of the subscriber's premise.
20
mounting holes on the mounting surface.
mounting surface and the weight of the ONT (each anchor rated to 15 lbs minimum) and
the weight of the SFU ONT (approximately 3.5 pounds).
Splice Housing
(1187770G1)

Figure 8. Enclosure Mounting Holes

Surface Mounting Holes
Surface Mounting Holes
OptiTap Housing
(1187771G1)
6418771XGX-5B