Figure 17. Euro Connector Installed - ADTRAN Total Access 362R Installation And Maintenance Manual

5. Tighten the retaining screws.
6. Reinstall the Power/Alarm Connector in the Electronics Module.
7. Tie wrap and route these wires as shown above. This will prevent the connector from
8. Reinstall the rubber grommet when closing the Electronics Module.
61187715G1-5B
Back of Electronics Module
Note: Even though there are brackets to
position the Euro-Connector wires,
we recommend not using them. Use
of these brackets can "bind" the wires
when the Electronics Module is closed.

Figure 17. Euro Connector Installed

coming loose when the Electronics Module is closed.
7 6 5 4 3 2 1
Power/Alarm
Connector
Tie Wrap wires
as shown
Rubber Grommet
Installation
29