WAGO-I/O-SYSTEM 750 XTR
750-614/040-000 Potential Distribution XTR
2.
Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.
Figure 7: Snap the I/O Module into Place (Example)
With the I/O module snapped in place, the electrical connections for the data
contacts and power jumper contacts (if any) to the fieldbus coupler/controller or
to the previous or possibly subsequent I/O module are established.
Pos : 54.12 /Serie 750 ( WAGO-I/O-SYST EM)/Monti eren/D emonti eren/XTR-I/O-Modul entfernen @ 28\mod_1486551166032_21.doc x @ 405491 @ 3 @ 1
4.2.2
Removing the I/O Module
1.
Remove the I/O module from the assembly by pulling the release tab.
Figure 8: Removing the I/O Module (Example)
Electrical connections for data or power jumper contacts are disconnected when
removing the I/O module.
Mounting
31
Manual
Version 1.1.0