Inserting And Removing Devices; Inserting The I/O Module; Figure 6: Insert I/O Module (Example) - WAGO 750-614/040-000 Manual

30 Mounting
Pos : 54.7 /All e Seri en ( Allgemei ne Module)/Ü bers chriften/Ebene 2/Geräte einfüg en und entfer nen - Ü berschrift 2 @ 3\mod_1231768483250_21.doc x @ 25950 @ 2 @ 1
4.2

Inserting and Removing Devices

Pos : 54.8 /All e Seri en ( Allgemei ne Module)/Sicherheits- und s ons tige Hi nweis e/Vorsic ht/Vorsicht: H eiß e Oberfläc he nicht ber ühr en! (allgemein) @ 6\mod_1264428115588_21.doc x @ 48610 @ @ 1
Do not touch hot surfaces!
The surface of the housing can become hot during operation. If the device was
operated at high ambient temperatures, allow it to cool off before touching it.
Pos : 54.9 /All e Seri en ( Allgemei ne Module)/Sicherheits- und s ons tige Hi nweis e/Gefahr/Gefahr: Nic ht an Ger äten unter Spannung arbeiten! @ 6\mod_1256193963573_21.doc x @ 43426 @ @ 1
Do not work when devices are energized!
High voltage can cause electric shock or burns.
Switch off all power to the device prior to performing any installation, repair or
maintenance work.
Pos : 54.10 /Serie 750 ( WAGO-I/O-SYST EM)/Wichtig e Erl äuter ung en (alte Struktur)/Sic her heits- und s onstige Hi nweis e/Ac htung/Ac htung: XTR nic ht unter -20 °C verdrahten oder umstec ken @ 15\mod_1367559895186_21.doc x @ 118480 @ @ 1
Temperature range applies to normal operation!
XTR I/O modules may be operated below −20 °C, but not wired and/or
reconnected.
Pos : 54.11 /Serie 750 ( WAGO-I/O-SYST EM)/Monti eren/D emonti eren/XTR-I/O-Modul ei nfüg en @ 28\mod_1486551092321_21.doc x @ 405487 @ 3 @ 1
4.2.1

Inserting the I/O Module

1. Position the I/O module so that the tongue and groove joints to the fieldbus
coupler/controller or to the previous or possibly subsequent I/O module are
engaged.

Figure 6: Insert I/O Module (Example)

Manual
Version 1.1.0
WAGO-I/O-SYSTEM 750 XTR
750-614/040-000 Potential Distribution XTR