Graco E-Flo 333587D Operation page 61

Error Location Type
MMUX ADM Advisory
MAD_ Pump Advisory
MBD_ Pump Advisory
MLC_ Pump Advisory
MLD_ Pump Advisory
MED_ Pump Advisory
MG2_ Pump Advisory
MG3_ Pump Advisory
P1C_ Pump Alarm or
P2C_ Deviation
(user
selectable)
333587D
Error
Error Name Description
USB Log 90% One or more
Full USB log is 90%
full.
Maint. Due Pump Maintenance
P_ due for pump
Maint. Due Driver Maintenance
P_ due for driver
Rebuild Platen Maintenance
Seals P_ due for platen
seals
Maint. Due Maintenance
Platen Valve P_ due for platen
valve
Maint. Due Maintenance
Dispense Valve due for
P_ dispense valve
Low Filter Low filter
Pressure P_ pressure drop
detected
High Filter High filter
Pressure P_ pressure drop
detected
Low Pressure P_ Measured
outlet pressure
less than
desired outlet
pressure minus
tolerance
Cause Solution
Data in the jobs or Download the data or disable USB errors.
events log has not
been downloaded
recently and logs
are nearly full
The number of Perform desired maintenance and reset the
pump cycles since pump cycles in the setup screen.
last reset has
exceeded the
maintenance limit
set
The number of Perform desired maintenance and reset the
driver cycles since driver cycles in the setup screen.
last reset has
exceeded the
maintenance limit
set
The number of Rebuild the platen seals if desired and reset
replaced drums the platen cycles in the setup screen.
since last cycles
reset has exceeded
the maintenance
limit set
The number of Perform desired maintenance and reset the
platen valve cycles platen valve cycles in the setup screen.
since last reset has
exceeded the
maintenance limit
set
The number of Perform desired maintenance and reset the
dispense valve dispense valve cycles in the setup screen.
cycles since last
reset has exceeded
the maintenance
limit set
The filter has an Replace the fluid filter.
opening in it
There is a clog in Clean out the manifold to reduce the
the manifold pressure.
Incorrect pressure Enter correct pressure tolerance percentage
tolerance in setup screen.
Failed pressure Check transducer, replace if failed.
transducer
No or insufficient Increase material flow.
material flow
Restrictor not Slowly close restrictor to build pressure.
closed enough
Troubleshooting
61