Graco E-Flo 333587D Operation page 60

Troubleshooting
Error Location Type
EDT_ AMZ Record
Only
EKA Pump Record
Only
EKM Pump Record
Only
EL0X ADM Record
Only
EM0X ADM Record
Only
EVUX ADM Advisory
F1D_ Pump Alarm or
F2D_ Deviation
(user
selectable)
F3D_ Pump Alarm or
F4D_ Deviation
(user
selectable)
L1C_ Pump Alarm
L2C_ Pump Deviation
60
Error
Error Name Description
Heat_ Module is All zone on
at desired heat module
temperature are at desired
temperature
Automatic The system has
Crossover to P_ success
crossover to
the other the
other pump
Manual The system has
Crossover to P_ received a
crossover
request
Power On The ADM was
powered on
Power Off The ADM was
powered off
USB Disabled USB
downloads/upl
oads are
disabled
Low Flow Rate Measured flow
P_ rate less than
desired flow
rate minus
tolerance
High Flow Rate Measured flow
P_ rate greater
than desired
flow rate plus
tolerance
Drum Empty P_ Drum is empty
Drum Empty P_ Drum level is
low
Cause Solution
All zones on heat No action necessary if the desired
module have temperature was reached.
successfully
reached the
desired
temperature
The alarm in the No action necessary.
system requested a
crossover to the
other pump
The system has No action necessary.
received a
crossover request
from the ADM or
CGM
The ADM was No action necessary.
powered on
The ADM was No action necessary.
powered off
USB Advisory will clear when drive is removed.
download/upload Enable USB downloads/uploads in setup
was attempted, but screen if desired and reinsert USB drive.
USB activity is
disabled within the
setup screen
Fluid supply too Increase fluid pressure to reach desired
low to achieve rate.
desired flow rate
Clog in fluid supply Check hose and other components in fluid
system supply system for clogs.
No air pressure to Turn on air to solenoid valves.
solenoid valves
No material supply Replace drum and prime pump if desired.
Incorrect flow Enter correct flow tolerance percentage in
tolerance setup screen.
Incorrect flow Enter correct flow tolerance percentage in
tolerance setup screen.
Drum is empty and Replace drum and prime pump if desired.
needs to be
replaced
Drum level sensor Verify level sensor is connected. Replace
is disconnected sensor if connection is good.
Fluid level in drum Clear deviation and return to normal pump
is low. Consider operation.
replacing soon
Drum level sensor Verify level sensor is connected. Replace
is disconnected sensor if connection is good.
333587D