DELIVERY AND DEALER SERVICE
Service Schedule
The following is a list of maintenance procedures
that must be performed on the rider. Most of the
points that are not described in this workshop
manual are found in the operator's manual.
Maintenance
Check for fuel and oil leaks
Check the parking brake
Checking the engine oil level
Check the fuel pump's air filter.
Check the safety switch, seat
Check the safety switch, lifting
lever
Check the safety switch, pedal
system
Check/clean the engine's cooling
air intake
Check the cutting unit:
• Attaching the blades
• Condition of the blades
(sharpness, shape, etc.)
Check the steering cables
(any play, etc.)
Check fastenings (screws, nuts,
etc.)
Start the engine and blades, listen
for unusual sounds
Clean under the cutting unit
Clean the transmission's cooling
air intake
Check the battery's acid level
Check the oil level in the hydraulic
tank
Check the condition of V-belts, belt
pulleys, etc.
Check for damage
Check the air pressure in the tyres
(60 kPa/9 PSI)
Clean thoroughly around the
engine.
Clean thoroughly around the
transmissions.
= Described in this workshop manual.
= Not described in this workshop manual
= Described in the operator's manual.
Page
Daily
Daily
mainte-
mainte-
nance
nance
before
after
-
45
23
-
102
102
102
-
86
90
92
42
-
-
-
-
22
24
-
-
24
-
-
or the operator's manual.
Weekly
At
mainte-
least
3)
once a
nance
year
Maintenance
interval in hours
25
50
100 300
17
English-