Husqvarna Rider PR 17 Workshop Manual page 66

4. Press in the cable casing in the forward
fastener in the centre bracket.
5. Tighten the hydrostatic transmission
cable clamp. Press the link joint onto its
fastener and attach the locking spring.
6. Attach the link joint to the rear part of the
hydrostatic transmission cable.
Screw 10-12 turns so that the link joint
has the right length.
7. Run the hydrostatic transmission cable
along with the other cables.
8. Position the hydrostatic transmission
cable in the casing's rear bracket.
9. Adjust the hydrostatic transmission cable
as shown, see "Adjusting the Hydrostatic
Transmission Cable" on page 46.
64
English-
REPAIR INSTRUCTIONS
Forward mount in centre bracket
Front clamp
Rear link joint
Adjusting the hydrostatic transmission cable