Replacing The Light Bulbs - Husqvarna Rider PR 17 Workshop Manual

Replacing the Light Bulbs

For information about the bulb type, see
"Electrical system" on page 10.
1. Unscrew the two screws holding the
cover on the power servo housing.
Lift up the cover and turn it around the
steering shaft.
2. Unscrew the two screws holding the
lamp insert.
Lift out the lamp insert.
3. Disconnect the cables from the bulbs.
4. Lift out the bulbs from the insert.
5. Insert the new bulbs. Make sure you use
your thumb to support the front.
6. Refit the cables, lamp insert and the
cover on the power servo housing.
ELECTRICAL SYSTEM
101
English-