IMPORTANT INFORMATION
When changing the cutting unit, you must
readjust the parallelism and cutting height.
Adjusting the Cutting Height Range
1.
Remove the plastic cover over the
hydraulic valve block.
2.
Raise or lower the entire cutting range by
screwing the nuts up or down.
Adjust so that the distance between
ground and the cutting unit's edge at the
front of the cover is 25 mm.
If the highest cutting height is raised by 5 mm /
3/16", the other fixed cutting heights will also
be raised by the same amount.
Checking and Adjusting the
Ground Pressure
In order to achieve the best mowing result the
cutting unit should follow the ground without
touching it too heavily. Pressure is adjusted
using a screw and spring on each side of the
rider.
1.
Check the air pressure in the tyres
60 kPa / 0.6 bar / 9 PSI.
2.
Place the machine on a flat surface.
3.
Put the lifting lever in the mowing
position.
REPAIR INSTRUCTIONS
Plastic cover
Adjusting the cutting height range
Checking the ground pressure
87
English-