11. Remove the inner circlip (1) by the lower
bearing (see illustration). The rear
carriage is now loose and can be moved.
Then loosen the outer circlip (2) and
remove the bearings from below.
12. Remove the upper bearings from above;
if they are stuck tap them from below.
13. Fit the new bearings and mount the
articulated steering in the reverse order
as set out for dismantling.
14. After mounting, the cable tension should
be checked, see "Remove the frame
plate by loosening the screws (two on the
power steering housing)." on page 42.
Check that the controls and cables are
properly adjusted, see "Adjusting the
Hydrostatic Transmission Cable" on
page 46.
15. Bleed the hydraulic system of excess air.
Top up the oil after test running.
Removing the Pendulum Shaft
1.
Jack up the rider in front of the rear
frame.
2.
Remove the pump unit, see "Drive Axles"
on page 51.
3.
Remove the fan.
4.
Remove the pump belt.
REPAIR INSTRUCTIONS
Lower bearings
Upper bearings
Jacking up
49
English-