Hose Bundle - Husqvarna Rider PR 17 Workshop Manual

17. Risk of incorrect assembly: Twist the
slider so that the lever ball enters the
front section of the slider hole and attach
the lever housing and lever. Tightening
torque, max. 8.5 Nm.
18. Risk of damaging the seals. Lubricate
them before fitting. Fit the check valve.
Tightening torque, max. 20 Nm.
19. Attach the control valve to the valve
block, see "Control Valve Replacement"
on page 112. Tightening torque, max. 12
Nm.
Pressure Limiting Valve
If the hydraulic pressure is too low, it can be
due to dirt trapped in the pressure limiting
valve.
IMPORTANT INFORMATION
Incorrect hydraulic pressure is almost
never due to an incorrectly adjusted
pressure limiting valve. Check the
hydraulic system thoroughly for faults
before changing the valve setting.
IMPORTANT INFORMATION
An excess flow valve that is set too high
will damage the power steering.

Hose Bundle

The hoses under the machine are collected
into a hose bundle. This is held together by
means of a plastic hose protection, which is
wound around the hoses.
When manufactured the hoses are colour
coded, but this may wear off or be damaged.
It is then possible to identify the hoses by the
punched part numbers.
1 Yellow
2 Blue
3 Green
4 Black
5 Red
116
English-
HYDRAULIC SYSTEM
535 47 85-01
535 48 84-01
535 48 78-01
535 48 77-01
544 01 71-01
Assembling the lever housing and lever
Pressure Limiting Valve
1
2
3
Hose marking
4
5