Fitting the Cutting Unit
!
WARNING!
Wear protective glasses when
assembling the cutting unit. The
springs that tension the belt can fly
off and cause personal injury.
1.
Place the machine on a flat surface and
apply the parking brake. Check that the
lever for setting the cutting height is in
the lowest position.
2.
Push the equipment frame down and
place the catch against the frame.
3.
Remove the drive belt and place it in the
belt holder.
4.
Push the unit in and put the guide plugs
in the grooves on the equipment frame,
one on each side.
REPAIR INSTRUCTIONS
81
English-