Husqvarna Rider PR 17 Workshop Manual page 40

2. Fit the belt pulley with tool no. 506 56 76-01
and tighten with a torque of 80 Nm/56 lbf. ft.
Use tool no. 506 89 92-01 to counter.
Place both belts in place on the belt pulley.
3. Fit the belt guide. Adjust the belt guide
against the lower belt in the belt pulley
as needed. Fit the skid guard.
4. Attach the throttle cable to the throttle
and fit the cable clip without tightening it.
Make sure that it goes into the proper
hole.
Move the accelerator to the full throttle
position. Push the cable's outer casing
as far to the left as possible and tighten
the cable clip.
Attach the choke cable to the carburettor
and fit the cable clip without tightening it.
Move the choke control to the full choke
position. Pull the cable's outer casing as
far to the right as possible and tighten
the cable clip.
5. Fit the exhaust pipe and tighten the
clamping screws and pipe clamps.
38
English-
REPAIR INSTRUCTIONS
Engine belt pulley
Belt guide
Exhaust system
506 56 76-01