Clear Minimum And Maximum Values (13. Menu Item) - Datcon DT4240 Series Operating Instructions Manual

DT4240 xx xx xx xx
Function
Sequence of operations 1. Enter the menu by typing the supervisor code.
Exit from the menu item 1. After you have performed the setting, press the MENU
Exit from the menu
20230503-V0
7.10. Clear minimum and maximum values (13. menu
item)
To clear the measured and stored mimimum and maximum
values.
The way the code should be type in is described in Chapter
7.1. Typing the code in. You see this on the display:

.
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
clear minimum-maximum value).
3. Enter the menu item by pressing the ENTER button.
4. The mnemonic
mnemonic is blinking.
5. Now you still have the possibility to exit. If you want to
exit, as you do not want to clear the minimum and maximum
values after all, press the MENU button.
6. If you want to clear the minimum and maximum values,
press the ▲ button to change the „NO" to „YES".

•
 = I do not want to clear

•
 = I want to clear
7. Press ENTER button you will see on the display:

(Ready = ready) the clear has done.
button. This takes you out from the menu item, and you see

this: .
(2. If you do not want to exit from the menu because you
want to perform other settings too, you may press the ▲
button to select the desired menu item.)
Press the MENU button. First the mnemonic
then the mnemonic
With this the storing of the settings is completed. The
instrument has exited the menu and goes on with the
measurement.

(Reset Minimum-Maximum =

is shown on the display. The

(Exit) are shown on the display.

(Save),
45