Fiber Optic Ethernet Ports; Sfp Transceivers - Siemens SIMATIC NET RUGGEDCOM RSG907R Installation Manual

IMPORTANT
RNA ports A and B must operate at the same speed. Inconsistent speed in these
ports will generate an alarm. Make sure to use SFPs with compatible speeds on ports
A and B.
4.2

Fiber Optic Ethernet Ports

The RUGGEDCOM RSG907R features four fixed Fiber optic Ethernet ports, each with
an LC (Lucent Connector) connector. Make sure the Transmit (Tx) and Receive (Rx)
connections of each port are properly connected and matched to establish a proper
link.
Port Types
1
1
2
Figure 4.3
LEDs
Each port features an LED that indicates the link/activity state of the port.
Green (Solid)
Green (Blinking)
Off
Specifications
For specifications on the available fiber optic Ethernet ports, refer to
ernet Port Specifications (Page
4.3

SFP Transceivers

The RUGGEDCOM RSG907R supports up to three Small Form-Factor Pluggable (SFP)
transceiver sockets, which are compatible with a wide array of SFP transceivers avail-
able from Siemens.
RUGGEDCOM RSG907R
Installation Manual, 02/2020, C79000-G8976-1387-09
2
Tx Connector
Rx Connector
LC Port
State
Link established
Link activity
No link detected
31)".
Communication Ports
4.2 Fiber Optic Ethernet Ports
Description
"Fiber Optic Eth-
27