Required Tools And Materials; Decommissioning And Disposal - Siemens SIMATIC NET RUGGEDCOM RSG907R Installation Manual

Introduction
1.3 Required Tools and Materials
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RSG907R:
AC power cord (16 AWG)
USB Type-B console port cable
Multi-mode fiber optic cables
Flathead screwdriver
Phillips screwdriver
Torx screwdriver
4 x M5 or #10-24 screws
1.4

Decommissioning and Disposal

Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated Configuration Manual.
Recycling and Disposal
For environmentally friendly recycling and disposal of this device and related acces-
sories, contact a facility certified to dispose of waste electrical and electronic equip-
ment. Recycling and disposal must be done in accordance with local regulations.
4
Tools/Materials Purpose
For connecting power to the device.
For connecting to the RUGGEDCOM RUGGEDCOM
RSG907R console interface.
For connecting the device to a LAN.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For attaching mounting brackets to the device.
For mounting the device to a panel.
Installation Manual, 02/2020, C79000-G8976-1387-09
RUGGEDCOM RSG907R