Fiber Optic Ethernet Ports - Siemens SIMATIC NET RUGGEDCOM RS416P Installation Manual

The total allowable power budget for all ports is 60 W. If the external power supply
is less than 60 W, to prevent exceeding the power budget, port priorities can be set
via the RUGGEDCOM RS416P operating system to disable low priority ports when
demand is too high. Ports can also be enabled/disabled and placed on a power
schedule to conserve power. For more information, refer to the "RUGGEDCOM
RS416P User Guide" for the RUGGEDCOM RS416P.
For information about connecting the external power supply, refer to
External PoE Power" (Page
LEDs
Each port features a dedicated LED that indicates the state of the port.
Yellow (Solid)
Yellow (Blinking)
Off
Pin-Out
The pin-out for the PoE ports is as follows:
8
Figure 4.3
Specifications
For specifications on the available PoE ports, refer to
Specifications" (Page
4.3

Fiber Optic Ethernet Ports

Fiber optic Ethernet ports are available with either MTRJ (Mechanical Transfer
Registered Jack), LC (Lucent Connector), SC (Standard or Subscriber Connector) or ST
RUGGEDCOM RS416P
Installation Manual, 11/2022, C79000-G8976-1019-11
17).
State
1
RJ45 Ethernet Port PoE Pin
Configuration
33).
Communication Ports
4.3 Fiber Optic Ethernet Ports
Description
Link established
Transmitting/receiving
No link detected
Pin
1
2
3
4
5
6
7
8
"PoE Power Supply
"Connecting
Description
RX + and Power -
RX - and Power -
TX + and Power +
Reserved (Do
Not Connect)
Reserved (Do
Not Connect)
TX - and Power +
Reserved (Do
Not Connect)
Reserved (Do
Not Connect)
25