DMP Electronics DUALCOM Series Programming And Installation Manual page 20

RECEIVER 1 PROG
ALARM NO YES
SPV/TRBL NO YES
O/C USER NO YES
TEST RPT NO YES
FIRST IP ADDR
000.000.000.000
FIRST IP PORT
2001
SECOND IP ADDR
000.000.000.000
SECOND IP PORT
2001
Digital Monitoring Products
18
RECEIVER 1 PROGRAMMING
This option allows you to set the options for the first receiver the communicator attempts
to contact when sending reports from the host panel and/or communicator. The
communicator supports communication up to two receivers.
ALARM REPORTS
Choose YES to enable Abort, Alarm, Alarm Restoral, Alarm Bell Silenced, Ambush, Exit
Error, and System Recently Armed reports to be sent to this receiver. The default is YES.
Choose NO to disable sending these reports to the receiver.
SUPERVISORY/TROUBLE REPORTS
Choose YES to enable Supervisory, Trouble, Trouble Restoral, Force Armed, and Fault
reports to be sent to this receiver. The default is YES.
Choose NO to disable sending these reports to the receiver.
OPENING/CLOSING AND USER REPORTS
Choose YES to enable Opening/Closing, Schedule and Code Changes, and Bypass reports
by user to be sent to this receiver. The default is YES.
Choose NO to disable sending these reports to the receiver.
TEST REPORT
Choose YES to enable the recall test report from the host panel and/or communicator to
be sent to this receiver. The default is YES.
Choose NO to disable sending these reports to the receiver.
FIRST IP ADDRESS
Enter the first (primary) IP address where the communicator sends cell messages. Enter
all 12 digits and leave out the periods. For example, enter IP address 192.168.0.250 as
192168000250. The periods display automatically.
FIRST IP PORT
Enter the first IP port number to be used with the first IP address. The IP port identifies the
port used to communicate messages with the communicator. The default IP port setting is
2001.
SECOND IP ADDRESS
Enter the second IP address where the communicator sends network messages. Enter all
12 digits and leave out the periods. The periods display automatically.
SECOND IP PORT
Enter the second IP port number to be used in conjunction with the second IP address. The
IP port identifies the port used to communicate messages to and from the communicator.
The default IP Port setting is 2001.
DualCom Programming and Installation Guide