How To Order - SMC Networks JXCEH Operation Manual

2.2 How to Order

How to order is shown below.
J X C E H
Electric equipment
Controller
Controller type
E EtherCAT
Number of shaft type and
Special specifications
1 axis, Power supply (24VDC)
1
High performance type
Single controllers are also shipped after setting the actuator specification parameters.
Confirm the combination of the controller and the actuator is correct.
Connect the designated electric actuator to the high performance controller.
<Check the following before use.>
•Check the actuator label for the model number.
Check that this matches the controller.
Electric actuator
Refer to the chart of the catalog for checking the chart of <Speed - Work load> of actuator.
-
Actuator Model
Stroke example:
For LEFS25FB-100B-S1CE17,
specify LEFS25FB-100.
(Enter from the electric actuator part number "LE"
to "stroke/ rotating angle")
BC
Note 1) Specified software (LEC-BCW) is required.
Mounting
7
8
Caution
LEFS25FB-100
Caution
-8-
*1)
Blank controller
Direct mounting
DIN rail
Controller
LEFS25FB-100
No. JXC※-OMY0008