Table of Contents
Advertisement
HOW TO CONTROL THE TAD FROM A REMOTE LOCATION
The TAD can be controlled from a telephone at a remote location so that you can listen to the messages
received, record outgoing messages and make new settings. Control from a remote location should be
protected by programming an access code on the TAD.
The tables that follow list the operations that can be performed from a remote location with the relevant
commands, while the rest of the section explains how to perform the operations.
KEY
SEQUENCE
# 0
Aborts the function in progress and exits from remote control mode
# 1
Plays unplayed messages
# 2
Plays all messages
While playing a message, repeats the previous one. At the end of the message, repeats
# 3
the message that has just been played.
# 4
Skips from the current message to the next one
# 5
Erases the current message
# 6
Erases all messages that have already been played
# 7
Provides access to set-up parameters.
KEY
1
Switches from TAD/FAX RX mode to FAX/TEL RX mode
2
Switches from TAD/FAX RX mode to AUTOMATIC RX mode
3
Enables TAD/FAX RX mode
4
Records OGM #1
5
Records OGM #2
6
Closes and confirms the OGM #1 or #2 recorded
7
Disables the recording of incoming messages
8
Enables the recording of incoming messages
KEY
When pressed after an operative sequence (# 1/6) aborts the operation without exiting
from remote control mode.
0
When pressed after a programming sequence (1/8), aborts the function in progress,
enabling operations to be continued using the # key.
In this case, to resume programming, press #7.
THE TELEPHONE ANSWERING DEVICE
OPERATIONS
SETTING
FUNCTION
117
Advertisement
Table of Contents
