Programming Chart And Description Of The Sub-Menu: Various Settings - Olivetti OFX 1200 Instruction Manual

PROGRAMMING CHART AND DESCRIPTION OF THE SUB-MENU: VARIOUS SETTINGS

b)
TX REPORT: OFF
c)
d)
e)
START: Confirms selection of the sub-menu and moves down to the associated parameters. Confirms a
parameter and the relative value and moves on to the next parameter.
< / > :
To select the value of a parameter by scrolling forward and backward through the values available.
Alternatively used to position the cursor on the characters that make up the value of a particular
parameter; in this latter case, once the position is reached you will be prompted to enter the
required value.
STOP: Interrupts the programming procedure and returns to the original operating mode display.
DESCRIPTION:
a) Allows you to enable or disable ECM (Error Correction Mode) which corrects transmission errors caused
by line interference. This function only works if it is enabled on both the communicating fax machines.
When it is selected the letter "E" will be shown on the display (last character in the first line after the
number or name of the correspondent).
b) Allows you enable or disable printing of the transmission report. If the third parameter is selected, the
fax machine will only print a transmission report in the case of failed transmission.
c) Allows you to select the speed at which the fax is transmitted (9600 or 4800 bits per second). 4800 bps
transmission is recommended on lines subject to interference.
d) Allows you to select the printing position of the sender's name and number and the time: outside the
text area immediately below the top edge of the sheet or inside the text area slightly lower than in the
previous case.
e) Allows you to select the type of scanning for the document to be transmitted or copied: standard or fine
resolution.
f) Adjusts the audible signal volume.
Reference sections: BASIC FUNCTIONS, REPORTS, TRANSMISSION, RECEPTION.
CONFIGURATION PARAMETERS
VARIOUS SETTINGS
a)
ECM: ON
TX REPORT: ALWAYS
TX SPEED 9600
HEADER INSIDE
COPY/TX RES. STD
f)
BUZZER VOL.: LOW
ò
ECM: OFF
ò
FAILED TX REPORT
ò
TX SPEED 4800
ò
HEADER OUTSIDE
ò
COPY/TX RES. FINE
ò
BUZZER VOL.: HIGH
55