Table of Contents
Advertisement
2.
Press the relevant one touch key, e.g. key 07.
The display will show the number memorised for the 07 key.
IF...
•
a name has also been stored, this will appear on the display.
•
a number has not been entered for this key, a message will be
displayed to this effect.
3.
The machine will automatically start to transmit the document. On
completion of the transmission, the message "TX COMPLETED"
will appear for a few seconds followed by the initial operating
mode display.
IF...
•
the transmission report function is selected (see section:
REPORTS), the machine will print out a report advising you of
the status of the transmission.
•
if you want to interrupt transmission at any point:
1) Press STOP. The display alternately indicates the machine
operation mode message and a message prompting you to
press
DOCUMENT, PRESS STOP).
2) Press STOP again. The document will be ejected and the
display will alternate between the machine operation mode
message and a message indicating that the transmission
has been interrupted. If the document to be removed
comprises more than one sheet, manually remove all the
sheets above the one in the ADF and then press STOP to
also eject the first sheet.
3) Press STOP again to return to the original operation mode.
HOW TO TRANSMIT A DOCUMENT USING THE SPEED DIAL CODES
You may also use the speed dial function to send a fax.
When you insert a document in the document feeder, the fax machine waits for you dial the fax number.
At this point, all you have to do is:
•
Press the SPEED DIAL key and enter the programmed 2-digit code.
v
The display shows the initial operating mode.
TRANSMISSION
STOP
to
remove
the
document
(REMOVE
FAX CALL
345678907861
CONNECTING
ê
NORMAL
AUTOMATIC RX
09-03-95
16:20
77
Advertisement
Table of Contents
